What are you looking for?
Search
Description:
2-in-1 USB water pump & mist maker can add a stunning mist effect to your pond, simultaneously achieving water flow circulation, rockery or fish tank to filter the bad smell with electro and ultrasonic technology.
Ideal for indoor fountains, water feature, and office use.
Perfects for use it in your pond, rockery, fishtank, vase, birdbath, etc, then it will create a magical atmosphere.
Easy to operate, put in the water and the voltage is 5V, then the mist appears.
No heat or chemicals used.
[Water Shortage Protection]Water level sensor. Long service life, effectively prevent dry burning.
[Mute and energy saving]Mute working and very low energy.
Recommended water depth: 3-6cm.
2-in-1 Water pump & Mist maker with 4 LED
Power:5W
Current: 100mA
Water pump flow rate:120L/H
Lift: 50cm
Water temperature: +5-40
Size:37.8x34x30mm
Color:Black / White
Cord length: 140cm
Mist maker
Size: 47x25mm
Water depth:3-6cm
Voltage:5V
Power:5W
Evaporation capacity:300ml/h
Cord length:140cm
Water temperature: +5-40
Color: Black / White
With 4LED or without led
Note: not include adapter
Specification for use of water pump
1. The water pump is a submersible pump that must be completely immersed in the water and then plugged in to circulate water;
2. When installing, removing, and cleaning the water pump, you must first unplug the power plug and cut off the power to ensure your safety;
3. If the water pump receives a serious collision, please check if the pump body is broken. If it is broken, please stop using it immediately
4. It is strictly prohibited to pull the power cord to avoid electric leakage and affect the safety of use.
Specification for use of atomizers
The atomizer is suitable for atomizing neutral (pH=7) slightly acidic or slightly acidic solutions, and cannot atomize in strong acid or alkaline solutions;
The water surface should be within 2 centimeters above the atomizer water level sensor, and the water depth should be kept at 7 centimeters. The atomization effect is suitable, but if the water is too deep, a buoy should be equipped;
Connect the atomizer to the power supply, place it flat in water, with the atomizer head facing upwards and completely submerged in water before turning on the power for operation;
After long-term operation of the atomizer, scale will accumulate on the outer shell and atomization plate surface, affecting its service life and atomization effect. Therefore, it is recommended to clean the atomizer every two weeks. When cleaning, it is recommended to gently wipe with a soft cloth and rinse with soft water;
During the installation process of the atomizer, it is important to avoid damaging the water level sensor to prevent the water level switch from causing the atomizer to lose control, which could result in dry burning of the atomizer and serious damage to the atomizer;
When stopping the use of the atomizer, first disconnect the power supply, and then remove the atomizer from the water;
When powered on, do not take the atomizer out of the water surface or hold it upside down. The atomizer should not be uneven when placed in the water, and the atomizer should be powered off before being taken out of the water surface;
If the atomizer is broken, immediately cut off the power and remove the atomizer to avoid entering the atomizer electrical board from the broken atomizer, which may cause the atomizer to short-circuit and burn out;
The fog generated by the atomizer needs to be removed by a fan to avoid the fog staying on the water surface and causing an increase in water temperature, thereby shortening the lifespan of the atomizer;
When multiple atomizers are placed in one compartment (with an interval of no more than 1 meter), the shells of each atomizer must be conductive to each other to prevent electrical corrosion and damage to the atomizer shells.
Added to cart successfully
You have successfully commented, please wait for review
Copied Successfully
You can enjoy up to 1 free gift!